How to Sew a Zipper into a Pillow, the Easiest Way Ever!

Yes, there are many tutorials online that teach how to put a zipper in a pillow.

But this method is Different. Easier. 

As I stitched up some pillows recently, I wondered if there was already a post out there with these instructions. To my amazement, there weren’t any. So I thought I’d share that with you today, along with some helpful tips that will save you time and trouble.

First, choose your fabric. Buy enough fabric to cover the front and back of each pillow you are making.

Buy a zipper (regular or invisible). I buy a zipper at least two inches shorter than one side of the square of fabric.

For example, if I’m making a 16″ pillow, I use a 14″ zipper. You’ll see why later.

If you have to cut your zipper down, do. Just make sure you stitch across the zipper teeth several times at the correct length so that your zipper tab doesn’t fall off while you’re constructing the pillow!

I am using a regular zipper in this tutorial.This is so that if you don’t have an invisible zipper foot, you can see how to insert the zipper.

Buy a pillow form for each pillow, make your own, or use one from a previously used pillow that’s still in good shape.

Measure the pillow form.

Most tutorials will tell you to cut the fabric one inch larger (all the way around) than your pillow form.

I’m here to tell you that you’ll be sorry if you do.

The finished pillow will look too baggy.

Cut the fabric one inch smaller than the form. You read that right… smaller!

For example, if your pillow form is 20″square, cut the fabric 19″ square.

I usually like to finish the edges with a serger, but you can use a zig zag stitch if you don’t have a serger.

IMG_6310

Next, place your zipper (invisible zipper or regular zipper) face down (right side of zipper to right side of pillow fabric), centering it on one side of the fabric square.

Using a zipper foot, stitch 1/4″ away from the zipper teeth all along the  zipper.

Make sure your needle is on the correct side of the zipper foot so that you don’t run over the zipper tab when you get to it.

IMG_6312

Turn the zipper so it is facing up and away from the pillow fabric as shown:

IMG_6315

Now, lay the other pillow fabric square on top of this one, right sides together, matching the edges. Pin. See photo below:

IMG_6319

Stitch 1/4″ away from the teeth, on the unsewn side.

Be sure to take out pins before you sew over them.

IMG_6320

Now, unzip the zipper part way. If you don’t, you’ll stitch the zipper inside and it will be tough to get it unzipped to turn the pillow right side out.

IMG_6321

Next, match the three remaining sides of the pillow squares, so that the edges line up.

Now, line up the zipper edges.

Start sewing on the zipper edge of the pillow about 1/2″ away from the zipper stitching toward the inside of the pillow.

Stitch around the 3 non-zipper sides and stop as indicated in the photo below:

IMG_6326

I know it seems strange that your stitching doesn’t match up with where you stitched the zipper on, but this is why this method is so awesome…you don’t have to line up your stitching and you don’t have to worry about the zipper teeth or the tail of the zipper showing!!!

Now, reach in and turn the pillow right side out and look at the zipper!

IMG_6329

Here is the view with the zipper closed:

IMG_6331

I made three of these pillows recently, and it took no time at all.

IMG_6361

See how nice and full they look?

And you don’t see the zippers on the bottom.

Bam! Done!